The Influence of the Initial Angle of the Cut and the Depth of Cut on the Shaping Process to Edge Wear of HSS Chisel

Anrinal Anrinal, Asmara Yanto, Hendriwan Fahmi, Yanto Darman

Abstract


The purpose of this research is to provide an overview of the effect of the initial angle of cut and depth of cut on the edge wear of the HSS chisel in the wear resistant steel cutting process using a scrap machine. This research was conducted using the KLOPP brand scrap machine, Type 550, Machine Code SC 01, Cutting speed (V) 15 m / min, Feeding motion (f) 0.4 mm / step, cutting time 5 minutes, using HSS Bohler scrap chisel Rapid Extra 1200 (3/8 "X 4") with variations in the initial angle of cutting (λ) 50 , 150, 250 and variations in the depth of cut (a) 0.4 mm, 0.8 mm and 1.2 mm. The results showed that an increase in the initial angle of cut and depth of cut tended to result in an increase in the edge wear of the HSS chisel.

Keywords


Initial Angle of the Cut, Depth of Cut, Edge Wear of HSS Chisel

Full Text:

PDF

References


Gere dan Timoshenko. (1997) Mekanika Bahan, Erlangga, Jakarta.

A.M. Syamsir, (1989) Dasar-Dasar Perancangan Perkakas Dan Mesin Perkakas, Rajawali, Jakarta.

A.Y. Junaidi dan Dharmawati, Analysis Cutting Tool High Speed Steel ( HSS ) With Cast Iron Material From Universal Lathe, in IRSTC 2015 PROCEDING, 2015, pp. 464–477.

I.R. Junaidi dan Weriono, Process Analysis of High Speed Steel Cutting Calculation (HSS) with S45 C Material On Universal Machine Tool, IJISRT (International J. Innov. Sci. Res. Technol., vol. 3, no. 1, pp. 447–456, 2018.

Junaidi, Analyze cutting tools (HSS) with cast iron material on Universal Lathes, Pekan Ilmiah Periode XXII-TA.2014/2015 Fakultas Teknik UISU, 2015, pp. 51–58.

D. Fondra (2008) Pengaruh Gerak Makan Dan Kedalaman Potong Proses Sekrap (Shaping) Datar Baja Tahan Aus (Wear Resistant) Terhadap Laju Keausan Tepi Pahat HSS, ITP, Padang

Junaidi. (2006) Pengaruh Gerak Makan Dan Kedalaman Potong Terhadap Keausan Tepi Pahat HSS Pada Proses Bubut Baja Tahan Karat, ITP, Padang.

T. Rochim, (1993) Teori dan Teknologi Proses Pemesinan, Laboratorium Teknik Produksi dan Metrologi Industri, Jurusan Teknik Mesin, FTI, ITB, Bandung.


Refbacks

  • There are currently no refbacks.


Copyright of JTM (p-ISSN: 2089-4880   e-ISSN:2598-8263)